While most skincare tools don't pair well with a bubble bath, the MyoLift TriWave is our favorite exception. This microcurrent device is the perfect tool to use in the tub for a fully-immersed, relaxing treatment. (Of course, we still recommend keeping your TriWave dry at all times to avoid damage.) Don't have a bathtub? Don't worry! You can still enjoy this treatment- all you need is a small bowl of water.
Here's what you'll need to get started:
• MyoLift TriWave
• TriWave Advanced Treatment Kit
• Bathtub or bowl large enough to submerge feet
Directions:
Start by running yourself a warm bath. If you don't have a bath, you can fill a bowl with warm water. Set it near a chair or stool where you can sit comfortably with your feet submerged in the bowl. Be sure the pads of your feet are firmly resting on the bottom of the bowl. Set your TriWave on the Rejuv setting at 400.
Place electrodes as described in either option 1 or option 2 below.
– Option 1 (See Figure Above): Target the face. Apply a water-based sheet mask of your choice. Place two electrodes on top of the mask on your forehead above each eye. If you have a smaller forehead, you may need to trim down the size of your electrode to fit better. Trim electrode to the size needed, being sure not to cut the wire.
– Option 2 (See Figure Above): Target the body. Place electrodes at the base of the neck where it meets your left and right shoulders.
